Owner's manual

Table Of Contents
Contents
I
CONTENTS
Chapter 1
Introduction
1.1 About the ControlNet Network Communication Option Board......................... 1-1
1.2 Where to Find Additional Information .............................................................. 1-3
1.3 Getting Assistance from Reliance Electric....................................................... 1-3
Chapter 2
Installation
2.1 Installing the ControlNet Option Board in 1 to 5 HP @ 460 VAC Drives............ 2-4
2.2 Installing the ControlNet Option Board in 7.5 to 10 HP @ 460 VAC Drives....... 2-8
2.3 Installing the ControlNet Option Board in 1 to 20 HP @ 230 VAC Drives ........ 2-12
2.4 Installing the ControlNet Option Board in 30 to 100 HP @ 230 VAC and
75 to 200 HP@460 VAC Drives ..................................................................... 2-16
2.5 Installing the ControlNet Option Board in 15 to 25 HP and 25 to 60 HP @
460 VAC Drives .............................................................................................. 2-21
2.6 Installing the ControlNet Option Board in 50 to 100 HP and 100 to 150 HP @
460 VAC Drives .............................................................................................. 2-26
2.7 Installing the ControlNet Option Board in 200 to 400 HP @ 460 VAC Drives.. 2-31
2.8 Installing the ControlNet Option Board in 2 to 43 Amp GV3000/SE
Bookshelf Drives............................................................................................ 2-34
2.9 Connecting the GV3000/SE Drive to a ControlNet Network.......................... 2-41
2.10 Connecting a Programming Device to the Option Board’s Network
Access Port ................................................................................................... 2-42
Chapter 3
Setting Up the GV3000/SE Drive
3.1 Setting the Control Type (P.048) ..................................................................... 3-1
3.2 Setting the Node Number (P.060) ................................................................... 3-2
3.3 Setting the Control Source (P.000).................................................................. 3-2
3.4 Setting the Run/Program Response (P.061) ................................................... 3-3
3.5 Setting the Communication Loss Response (P.062)....................................... 3-4
3.6 Setting the Network Output Register Sources P.066 to P.069) ....................... 3-6
3.7 Option Port: Type and Version (P.065) ........................................................... 3-7
3.8 Network Reference Source (P.063) and Network Trim Reference
Source (P.064) ................................................................................................ 3-7
Chapter 4
Programming the Drive
4.1 About ControlNet Network Communication ..................................................... 4-1
4.2 Configuring Drive Reference and Feedback Data as Scheduled Transfers.... 4-1
4.2.1 Configuring Scheduled Data Transfers ................................................. 4-2
4.2.2 Programming Scheduled Drive Reference Data ................................... 4-3
4.2.3 Using Scheduled Drive Feedback Data ................................................ 4-4
4.3 Using Unscheduled Transfers ......................................................................... 4-7
4.3.1 Programming the MSG Instruction in a PLC-5 ...................................... 4-7
4.3.2 About MSG Instruction Timing .............................................................. 4-8
4.3.3 About the Files You Can Access........................................................... 4-8