User Manual

5-4

AutoMax Network Communication Option Board for the GV3000/SE AC Drive

13 (con’t.) 13 Analog input signal loss (AIn) 350ms

14 Reserved

15 Fatal system error 350ms

14 0 to 7 Number of error log entries 350ms

8 Parameter processing error flag 350ms

9 to 15 Reserved

15 0 to 7 Error log entry (second most recent error) 350ms

8 to 15 Error log entry (most recent error) 350ms

16 Control Source (P.000) 0 = Front-panel (Local); 1 = Terminal

strip; 2 = Option Port (Network master)

3 = Serial Port (PC-HOST)

350ms

17 Accel Time 1 (RAMP 1) (P.001) 1 = 0.1 seconds 350ms

18 Decel Time (RAMP 1) (P.002) 1 = 0.1 seconds 350ms

19 Minimum Speed (P.003) V/Hz: 1 = 0.1 Hz. Vector: 1 = 1 RPM 350ms

20 Maximum Speed (P.004) V/Hz: 1 = 0.1 Hz. Vector: 1 = 1 RPM 350ms

21 Current Limit (P.005) 1 = 1% 350ms

22 Trim Gain Percentage (P.015) 1 = 0.1% 350ms

23 Draw Gain Percentage (P.016) 1 = 0.1% 350ms

24 Speed Regulator Proportional Gain (U.012). Vector only. 1 = 0.01 350ms

25 Speed Regulator Integral Gain (U.013). Vector only. 1 = 0.01 350ms

26 Status word 2

0 Torque or speed regulation. Vector only. 1 = speed 5ms

1 Auto or manual (local) reference selected 1 = manual 5ms

2 Outer control loop enabled 1 = enabled 5ms

3 to 15 Reserved

27 Elapsed Time Meter (P.029) days 350ms

28 Network Connection Type (P.061) 0 = basic; 1 = full 350ms

29 Option Port: Communication Loss Response (P.062) 350ms

30 0 to 7 Option Port: Network Reference Source (P.063) 0 = direct; 1 to 8 = broadcast 1 to 8 350ms

8 to 15 Option Port: Network Trim Reference Source (P.064) 0 = direct; 1 to 8 = broadcast 1 to 8 350ms

31 Software Version Number (P.098) 601 = Version 6.01 350ms

Table 5.2 – Register Assignment for Drop_1 Area Read Only Registers (Continued)

*Update Times: 5 ms = 5 ms. 350 ms = 350ms or less.