User Manual

5-2

AutoMax Network Communication Option Board for the GV3000/SE AC Drive

Table 5.2 – Register Assignment for Drop_1 Area Read Only Registers

0 Status word 1 (includes terminal strip digital inputs) 5ms

0 Drive ready 5ms

1 Drive running 5ms

2 Fault active 5ms

3 Run/jog mode status 1 = Jog 5ms

4 Forward/reverse reference invert command 1 = Reverse 5ms

5 Stop sequence in progress 5ms

6 Tune/config input enable (copied from Drop_1, register 32, bit 14) 5ms

7 Tune/config update synchronization flag (copied from Drop_1, register 32, bit 15) 5ms

8 Terminal strip digital input 1 (start) 5ms

9 Terminal strip digital input 2 (stop) 5ms

10 Terminal strip digital input 3 (fault reset) 5ms

11 Terminal strip digital input 4 (run/jog select) 5ms

12 Terminal strip digital input 5 (function loss) 5ms

13 Terminal strip digital input 6 5ms

14 Terminal strip digital input 7 5ms

15 Terminal strip digital input 8 5ms

1 Selected speed reference value Vector: 4095=Motor Top Speed (U.017)

V/Hz:4095=Maximum Speed (P.004)

5ms

2 Speed reference sum. Limit block output, including trim and draw 5ms

3 Speed feedback Vector: 4095 =Motor Top Speed (U.017) 5ms

4 Terminal strip analog input value (conditioned with offset, gain, and inversion) ±4095 = ±10V 5ms

5 Output speed/frequency (front panel RPM display) 5ms

Output voltage (front panel

VOLTS display)

5ms

Output current (front panel

AMPS display = amps x 10)

5ms

8 Network output register 1 (value determined by Drop_2, register 45, bits 0 to 7, (P.066)) 5ms

9 Network output register 2 (value determined by Drop_2, register 45, bits 8 to 15 (P.067)) 5ms

10 Network output register 3 (value is determined by Drop_2, register 46, bits 0 to 7 (P.068)) 5ms

11 Network output register 4 (value determined by Drop_2, register 46, bits 8 to 15 (P.069)) 5ms

*Update Times: 5 ms = 5 ms. 350 ms = 350ms or less.