User Manual

III
Table of Contents
List of Figures
Figure 2.1 – Identifying the Drive Model Number ............................................. 2-1
Figure 2.2 – 30 to 50 HP Drive Components and Locations ............................ 2-3
Figure 2.3 – 60 to 100 HP Drive Components and Locations .......................... 2-4
Figure 2.4 – Regulator Board Components and Locations .............................. 2-6
Figure 2.5 – Jumper J4 Settings for Analog Input Speed Reference ............... 2-8
Figure 2.6 – Jumper J17 Settings for Analog Outputs ..................................... 2-9
Figure 2.7 – Typical Terminal Strip Connections.............................................. 2-10
Figure 2.8 – Keypad/Display ............................................................................. 2-11
Figure 2.9 – Base Board Jumper Locations ..................................................... 2-12
Figure 3.1 – Drive Dimensions ......................................................................... 3-3
Figure 3.2 – Recommended Air Flow Clearances ............................................ 3-4
Figure 3.3 – How to Measure Motor Lead Lengths .......................................... 3-7
Figure 4.1 – Terminal Locations ....................................................................... 4-3
Figure 5.1 – Typical AC Input Electrical Connections ...................................... 5-3
Figure 5.2 – Typical DC Input Electrical Connections ...................................... 5-4
Figure 7.1 – Two-Wire Start/Stop Sample Control Wiring ................................ 7-4
Figure 7.2 – Three-Wire Start/Stop Sample Control Wiring ............................. 7-5
Figure 7.3 – Encoder Wiring Connections ........................................................ 7-8
Figure 9.1 – DC Bus Voltage Terminals ........................................................... 9-2