User Manual

GV3000/SE 230 VAC 30-100 HP Drive, Hardware Reference Version 6.04

3.2.5 Verifying Power Module Output Current Rating is Greater

Than Motor Full Load Amps......................................................... 3-9

Chapter 4 Mounting the Drive, Grounding, and Finding Wire Routing Locations

4.1 Mounting the Drive .................................................................................... 4-1

4.1.1 Verifying the Drive's Watts Loss Rating ...................................... 4-1

4.2 Routing Input, Motor Output, Ground, and Control Wiring

for the Drive .............................................................................................. 4-1

4.3 Grounding the Drive .................................................................................. 4-2

Chapter 5 Installing Input Power Wiring

5.1 Installing Transformers and Reactors (Optional)...................................... 5-1

5.2 Installing Fuses for Branch Circuit Protection .......................................... 5-2

5.3 Installing a Required External/Separate Input Disconnect ....................... 5-2

5.4 Installing Power Wiring from the AC Input Line to the Drive's

Power Terminals ....................................................................................... 5-5

5.5 Installing Power Wiring from an External DC Bus to the

Drive's Internal DC Bus Terminals............................................................ 5-5

Chapter 6 Installing Output Power Wiring

6.1 Installing Output Contactors (Optional) .................................................... 6-1

6.2 Installing Mechanical Motor Overload Protection (Optional) .................... 6-1

6.3 Installing Output Wiring from the Drive Output Terminal to the Motor ..... 6-1

Chapter 7 Wiring the Regulator Board Terminal Strip

7.1 Stopping the Drive .................................................................................... 7-6

7.2 Wiring the Encoder Feedback Device (FVC Regulation Only) ................. 7-6

7.3 Wiring the Signal and Control I/O ............................................................. 7-9

Chapter 8 Completing the Installation

8.1 Checking the Installation ........................................................................... 8-1

8.2 Powering Up After Installation is Complete .............................................. 8-2

Chapter 9 Troubleshooting the Drive

9.1 Test Equipment Needed to Troubleshoot ................................................. 9-1

9.2 Drive Alarms and Faults ........................................................................... 9-1

9.3 Verifying That DC Bus Capacitors are Discharged .................................. 9-1

9.4 Checking Out the Power Module with Input Power Off ............................ 9-2

9.5 Replacement Parts ................................................................................... 9-4

Appendix A Technical Specifications .................................................................................... A-1

Appendix B 30-100 HP GV3000/SE System Wiring Diagram ............................................... B-1