Hardware Ref, Installation, and Troubleshooting Owner's manual

Contents
III
List of Figures
Figure 2.1 – Identifying the Drive Using the U. S. Model Number ............................ 2-1
Figure 2.2 – Identifying the Drive Using the European Stock Number ..................... 2-2
Figure 2.3 – 2 to 15 Amp Drive Component Locations............................................. 2-3
Figure 2.4 – 24 to 30 Amp Drive Component Locations........................................... 2-4
Figure 2.5 – 43 Amp Drive Component Locations.................................................... 2-5
Figure 2.6 – Regulator Board Component Locations ............................................... 2-6
Figure 2.7 – Jumper J4 Settings for Analog Input Speed Reference ....................... 2-8
Figure 2.8 – Jumper J17 Settings for Analog Outputs.............................................. 2-9
Figure 2.9 – Typical Terminal Strip Connections.................................................... 2-10
Figure 2.10 – Keypad/Display................................................................................. 2-11
Figure 2.11 – Output Relay Terminal Strip ............................................................. 2-12
Figure 3.1 – Dimensions for 2 to 30 Amp Drives ...................................................... 3-3
Figure 3.2 – Dimensions for 43 Amp Drives ............................................................. 3-4
Figure 3.3 – How to Calculate Motor Lead Lengths ................................................. 3-7
Figure 4.1 – Wire Routing Locations for 2 to 15 Amp Drives.................................... 4-3
Figure 4.2 – Wire Routing Locations for 24 to 30 Amp Drives.................................. 4-4
Figure 4.3 – Wire Routing Locations for 43 Amp Drives........................................... 4-5
Figure 5.1 – Typical AC Input Electrical Connections............................................... 5-3
Figure 7.1 – Two-Wire Start/Stop Sample Control Wiring ........................................ 7-3
Figure 7.2 – Three-Wire Start/Stop Sample Control Wiring...................................... 7-3
Figure 7.3 – Encoder Wiring Connections ................................................................ 7-6
Figure 7.4 – Wiring the Terminal Strip - Detail.......................................................... 7-7
Figure 8.1 – Braking Resistor Wiring Connections ................................................... 8-4
Figure 10.1 – DC Bus Voltage Terminals (2 to 15 Amp Drives) ............................. 10-2
Figure 10.2 – DC Bus Voltage Terminals (24 to 30 Amp Drives) ........................... 10-3
Figure 10.3 – DC Bus Voltage Terminals (43 Amp Drives) .................................... 10-4