Software Start-Up and Ref. Owner manual
Table Of Contents
- GV3000/SE AC General Purpose (V/Hz) and Vector Duty Drive, 1 - 20 HP, 230V AC Software Start-Up and Reference Manual D2-3387-5
- Important User Information
- Document Update
- Summary of Changes
- Table of Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1 - Starting Up the Drive for Volts/Hertz Regulation
- Chapter 2 - Starting Up the Drive for Vector Regulation
- Chapter 3 - Using the Keypad/Display To Program, Monitor, and Control the Drive
- Chapter 4 - Programming Reference
- Chapter 5 - Troubleshooting the Drive Using Error Codes
- Appendix A - Alphabetical Listing of Parameters
- Appendix B - Record of User Parameter Settings
- Appendix C - Power Module-Dependent Parameter Default Values (230 V Series)
- Appendix D - Default Parameter Settings
- Appendix E - Configuring the Digital Inputs When the RMI Board Is Installed in the Drive
- Appendix F - Using the Terminal Strip Analog Input
- Appendix G - Drive Regulation Overview
- Back Cover / Publication D2-3387-5 July 2013
G-7
Drive Regulation Overview
Figure G.6 – Vector Speed PI and Iq Reference Limit Selection
f(P.005,
U.006)
Iq ref high limit
Iq ref low limit
hi
hi
hi
low
low
low
f(r.025)
None
RMI
Netw
P.000 = OP
Netw com active
Netw Speed PI low limit
(drop 1, reg 60)
Netw Speed PI high limit
(drop 1, reg 59)
Current Limit (P.005)
Magnetizing Current (U.006)
high
high
high
low
Option board
type
low
low
Iq ref limits
Speed PI high limit
Speed PI low limit
"Netw" can be AutoMax, ControlNet, or DeviceNet
Netw speed PI limit enable
(drop 1, reg 53, bit 2)