Software Start-Up and Ref. Owner manual
Table Of Contents
- GV3000/SE AC General Purpose (V/Hz) and Vector Duty Drive, 1 - 20 HP, 230V AC Software Start-Up and Reference Manual D2-3387-5
- Important User Information
- Document Update
- Summary of Changes
- Table of Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1 - Starting Up the Drive for Volts/Hertz Regulation
- Chapter 2 - Starting Up the Drive for Vector Regulation
- Chapter 3 - Using the Keypad/Display To Program, Monitor, and Control the Drive
- Chapter 4 - Programming Reference
- Chapter 5 - Troubleshooting the Drive Using Error Codes
- Appendix A - Alphabetical Listing of Parameters
- Appendix B - Record of User Parameter Settings
- Appendix C - Power Module-Dependent Parameter Default Values (230 V Series)
- Appendix D - Default Parameter Settings
- Appendix E - Configuring the Digital Inputs When the RMI Board Is Installed in the Drive
- Appendix F - Using the Terminal Strip Analog Input
- Appendix G - Drive Regulation Overview
- Back Cover / Publication D2-3387-5 July 2013
V
Table of Contents
Table 3.1 – Display Range Examples ............................................................. 3-5
Table 3.2 – Drive Status LEDs ........................................................................ 3-8
Table 3.2 – Monitor Mode LEDs ...................................................................... 3-9
Table 4.1 – Speed Reference Source Based on P.000 and AUTO/MAN
Key Status .................................................................................... 4-7
Table 4.2 – Function Selection for Digital Inputs 6, 7, and 8 .......................... 4-14
Table 4.3 – Acceptable P.007 and P.008 Selection Combinations................. 4-18
Table 4.4 – Preset Speed Digital Inputs .......................................................... 4-33
Table 4.5 – Faults That Can Be Auto Reset.................................................... 4-37
Table 4.6 – AUTO/MAN Key Status Based on P.000 and P.052 .................... 4-41
Table 4.7 – STOP/RESET Key Status Based on P.000 and P.055 ................ 4-46
Table 5.1 – List of Alarm Codes ...................................................................... 5-2
Table 5.2 – List of Fault Codes........................................................................ 5-3
Table 5.3 – Fatal Fault Codes That Can Be Reset ......................................... 5-9
Table F.1 – Analog Input Conversion Scaling for Speed or Trim Reference .. F-2
Table F.2 - Analog Input Conversion Scaling for Torque Reference.............. F-4
List of Tables