Reference Manual Owner's manual

Publication GMLC-5.2 - November 1999
62 Configuring Axis Use
Note: Default names are shown in the examples above. If you had
renamed AXIS0 to First on the Axes page of the Configure
Control Options dialog box, First would replace AXIS0.
General
The General page of Configuring Your Axis is where you make the
fundamental settings for an axis. The selections you make on this page
determine how you can use this axis.
To configure the General page, make entries in the following fields:
Physical Axis
The default name of the physical axis (AXIS0, AXIS1, AXIS2, or
AXIS3) is automatically displayed.