User Manual

Contents I
CONTENTS
Chapter 1 Introduction
1.1 Before You Start .............................................................................................. 1-1
1.2 Where to Find Additional Information .............................................................. 1-1
1.3 Getting Assistance from Reliance Electric....................................................... 1-1
1.4 Related Hardware and Software ..................................................................... 1-2
1.5 AutoMax Network Option Board Description ................................................... 1-2
Chapter 2 Installation
2.1 Installing the Network Option Board ................................................................ 2-1
2.2 Connecting the Drive to an AutoMax Network................................................. 2-3
Chapter 3 Drive Configuration
3.1 Setting Up the Drive for Network Communication ........................................... 3-1
3.2 Selecting a Network Reference Source........................................................... 3-2
3.3 How the Drive Responds to a Loss of Network Communication ..................... 3-2
3.3.1 Setting NETW COMM LOSS SELECT (P.901)
(FlexPak 3000 Drives Only) .................................................................. 3-3
Chapter 4 Programming
4.1 Selecting a Register Map (FlexPak 3000 Drives Only) ................................... 4-1
4.2 How the Control Source Selection Affects Data Transfers.............................. 4-1
4.3 About Network Transfer Rates ........................................................................ 4-1
4.3.1 I/O Update Enable Logic Summary....................................................... 4-3
4.4 Setting Up Data Types That Can Be Transferred............................................ 4-3
4.5 Tune/Config Update Synchronization Flag ...................................................... 4-4
4.6 Monitoring Unacceptable Parameter Values ................................................... 4-5
4.7 Timing Requirements ...................................................................................... 4-5
4.8 Drive Ready Status Bit .................................................................................... 4-6
4.9 Display of Parameter Values Over the AutoMax Network............................... 4-6
4.10 Parameters That Are Not Accessible Over the AutoMax Network .................. 4-7
4.11 Parameters That Are Only Available in the FlexPak Alternate Register Map.. 4-8
4.12 Settings for Analog and Frequency Outputs.................................................... 4-8
Chapter 5 FlexPak 3000 Drives: Original Register Map
5.1 Accessing the Original Register Map .............................................................. 5-1
5.2 Finding Data in the Original Register Map Tables ........................................... 5-1
Chapter 6 FlexPak 3000 Drives: Alternate Register Map
6.1 Accessing the Alternate Register Map ............................................................ 6-2
6.2 Diagnosing Processing Errors ......................................................................... 6-2
6.3 Finding Data in the Alternate Register Map Tables......................................... 6-4