User Manual

ManualsBrandsRockwell Automation ManualsEquipmentFlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board

3-4

AutoMax Network Communication Option Board

P.901 = USE LAST REF (1)

When

NETW COMM LOSS SELECT (P.901) is set to USE LAST REF and network

communication is lost, the following occurs:

• The drive continues to run, using the last reference received from the network

master.

• A NETWORK COMMUNICATION TIMEOUT alarm (A00004) is generated.

• An entry is made into the drive’s alarm log for each active-to-inactive transition of

network communication status.

• If network communication is re-established and the drive is still running, the drive

will again follow the reference and sequencing control inputs supplied by the

network master.

You can stop the drive using the hardwired stop input or the

OIM STOP/RESET key.

However, you cannot restart the drive until network communication is re-established or

CONTROL SOURCE SELECT (P.000) is changed.

P.901 = USE TRMBLK REF (2)

When

NETW COMM LOSS SELECT (P.901) is set to USE TERMBLK REF (2) and network

communication is lost, the following occurs:

• The drive continues to run, using the auto reference value selected by AUTO

REFERENCE SELECT (P.103)

(or Regulator board terminals 19 and 20?)

• A NETWORK COMMUNICATION TIMEOUT alarm (A000014) is generated.

• If network communication is re-established and the drive is still running, the drive

will again follow the reference and sequencing control inputs supplied by the

network master.

You can stop the drive using the hardwired stop input, the

OIM STOP/RESET key, or the

hardwired stop input (coast/DB stop, Regulator board terminal 8). However, you

cannot restart the drive until network communication is re-established or

CONTROL

SOURCE SELECT (P.000) is changed.

P.901 = USE TRMBLK CNTL (3)

When

NETW COMM LOSS SELECT (P.901) is set to USE TRMBLK CNTL (3), and network

communication is lost, the following occurs:

• The drive continues to run using the Regulator board terminal strip as the source for

all control (run, jog, stop, fault reset, direction, and OCL enable) and speed (auto)

reference signals.

• A NETWORK COMMUNICATION TIMEOUT alarm (A000014) is generated.

• The Speed Loop PI Reset and Underwind/Overwind bits cannot be changed while

operating in this mode. They will remain at the last values received from the

network.

If network communication is re-established and the drive is still running, the drive will

again frollow the reference and sequencing control inputs supplied by the network

master.