Owner manual

APPENDIX D
FlexPak 3000 49’1340 e
D-4
Forward/Reverse
Command
INV
* NO TRIM
AUTO MODE MIN BYPASS
(see Note 1)
(DRAW PERCENTAGE OUT)
0
ACCEL TIME
1 + DRAW PERCENT
ACCELERATION TIME
(TRIM OUTPUT)
TRIM MODE SELECT
INCREMENTAL
PROPORTIONAL
(SPD SOURCE SELECT OUT)
TOP SPEED
From Speed Reference Source Select Block Diagram
(w/hysteresis)
MIN BYPASS
SUM
+
+
MIN
LIMIT
IN
MINIMUM SPEED
REV DISABLE
MAX
OUT
REVERSE DISABLE
EN
MAXIMUM SPEED
* = Default Selection
PROPORTIONAL
INCREMENTAL
TRIM MODE SELECT
* NO TRIM
(SPEED RAMP INPUT TP)
Ramp Stop Command
0
On
Off
DEC
ACC
SCURVE
SMOOTHING
S-CURVE ROUNDING
AUTO MODE RAMP BYPASS (see Note 1)
(SPEED RAMP OUTPUT)
ON
* OFF
Note 1: "AUTO MODE MIN BYPASS" and "AUTO MODE RAMP BYPASS" are valid only when the drive is in Auto Mode. During a Ramp Stop Command, the S-curve ramp will NOT be bypassed, regardless of the drive mode (Auto/Manual) or the state of the "AUTO MODE RAMP BYPASS" parameter.
From Speed Reference Source Select Block Diagram
TRIM * DRAW PERCENT
----------------------------
To Speed Reference Mode Select Block Diagram
P.193
D3(B)
D3(C)
P.110
P.004
P.003
P.015
P.198
P.001
DECELERATION TIME
TRIM MODE SELECT
PROPORTIONAL
INCREMENTAL
* NO TRIM
DECEL TIME
----------------------------
1 + DRAW PERCENT
P.110
P.002
P.197
P.196
P.199
P.112
D5(D)
P.111
P.014
To Current Minor Loop Reference Block Diagram
D9(E)
RATE
RAMP STOP DECEL TIME
TRIM MODE SELECT
PROPORTIONAL
INCREMENTAL
* NO TRIM
RAMP STOP DEC. T.
----------------------------
1 + DRAW PERCENT
P.110
P.110
P.018
Ramp Stop
Command
On
Off
Internal Sequenzing
Jogging
Off
On
STOP DECEL SELECT
JOG RAMP OUTPUT From Speed Reference Mode Select Block
RAMP STOP DECEL TIME
* DECELERATION TIME
0
OR
Jogging speed loop enable Internal Sequenzing
IV
RST
P.122
Figure D.4 - Speed Reference Ramp