User guide

C-9
METER OUT
2
SELECT
(P.405) •
CML FEEDBACK
(P.397)
•
CML REFERENCE
(P.396)
•
CML ERROR
(P.398)
•
SPD LOOP FEEDBACK
(P.296)
•
SPD LOOP REFERENCE
(P.295)
•
SPD LOOP ERROR
(P.297)
•
SPD LOOP OUTPUT
(P.299)
•
SPEED RAMP OUTPUT
(P.199)
•
SPEED RAMP INPUT TP
(P.198)
•
SPD SOURCE SELECT OUT
(P.193)
•
TRIM OUTPUT
(P.197)
•
ARMATURE VOLTAGE
(P.289)
•
ANALOG TACH FEEDBACK
(P.291)
•
PULSE TACH FEEDBACK
(P.292)
•
ZERO
•
FULL SCALE
•
POWER OUTPUT
•
OCL REFERENCE
(P.845)
•
OCL RAMP OUTPUT
(P.846)
•
OCL FEEDBACK
(P.847)
•
OCL OUTPUT
(P.848)
•
FIELD REFERENCE
(P.590)
•
FIELD FEEDBACK
(P.589)
•
NETW IN REG
1 (P.905)
•
NETW IN REG
2 (P.906)
•
NETW IN REG
3 (P.907)
SPD LOOP
FEEDBACK
METER
OUT
2
ZERO ADJ
(P.403) –200 to 200 0
MINIMUM SPEED
(P.003) 0 to
MAXIMUM SPEED
(
RPM
or user-
defined units)
250
RPM
MOP
ACCEL TIME
(P.115)
ACCELERATION TIME
to 300.0 seconds 5.0 seconds
MOP DECEL TIME
(P.120)
DECELERATION TIME
to 300.0 seconds 5.0 seconds
MOP RESET ENABLE
(P.116) •
OFF
•
ON
OFF
MOTOR
HOT FLD AMPS
(P.510) 0.11 to installed supply rating (4.00,
10.00, or 20.00 amps)
0.01 amps
MOTOR RATED ARM AMPS
(P.008) 0 to 3000.0 amps 8.0 amps
MOTOR RATED ARM VOLTS
(P.009) 160 to 675 volts 240 volts
Table C.1 – Parameter Settings Quick Reference Table (Continued)
Parameter
Parameter Selection/
Adjustment Range
Initial Factory
Setting (Default)
Your Data
Date Setting