User guide

8-16 ControlNet Network Communication Option Board For Use With FlexPak 3000 and WebPak 3000 DC Drives
N10:234 LEVEL DETECT 2B SEL P.611 Config 0 = LEVEL REGISTER 1
1 =
LEVEL REGISTER 2
2 =
CML SPEED REFERENCE
3 = CML REFERENCE
4 = CML FEEDBACK
5 = CML ERROR
6 = SPD SOURCE SELECT OUT
7 = SPEED RAMP OUTPUT
8 = SPD LOOP REFERENCE
9 = SPD LOOP FEEDBACK
10 = SPD LOOP OUTPUT
11 = TRIM OUTPUT
12 = NORM FIELD REF
13 = FIELD DELTA
14 = FIELD FEEDBACK
15 = FIELD REFERENCE
16 = TEN LOOP ERROR
17 = TENSION DEMAND
18 = TEN/DANCER FDBK SCALED
19 = POS LOOP ERROR
20 = DANCER LOADING
21 = OCL OUTPUT
22 = OCL PARALLEL OUT
23 = NORM ROLL DIAMETER
24 = LOSSES COMPENSATION
25 = INERTIA COMPENSATION
26 = INSTANTANEOUS INERTIA
27 = TAPER PERCENT
28 = CURRENT MEM COMMAND
29 = STALL TENSION COMMAND
30 = NETW IN REG 1
31 =
NETW IN REG 2
N10:235
CURRENT/SPEED SWITCH P.811 Config 0 = DISABLE, 1 = ENABLE
N10:236 NETW CONNECT TYPE P.910 Config 0 = BASIC, 1 = FULL
N10:237 AMX NETW REF SELECT P.911 Config 0 = DIRECT
N
= BROADCAST N, where N = 1 to 8
N10:238
|
N10:273
Reserved --- --- Reserved (future parameter expansion)
Table 8.1 – File N10:x (Drive Read/Write Parameters) for WebPak 3000 Drives (Continued)
File
Address Parameter Name
Parameter
Number Type Scale