User guide

8-10 ControlNet Network Communication Option Board For Use With FlexPak 3000 and WebPak 3000 DC Drives
N10:224 ANLG OUT 3 SELECT P.418 Config 0 = CML FEEDBACK
1 = CML REFERENCE
2 = CML ERROR
3 = SPD LOOP FEEDBACK
4 = SPD LOOP REFERENCE
5 = SPD LOOP ERROR
6 = SPD LOOP OUTPUT
7 = SPEED RAMP OUTPUT
8 = SPD RAMP INPUT TP
9 = ARMATURE VOLTAGE
10 = ANALOG TACH FEEDBACK
11 = ENCODER FEEDBACK
12 = SPD SOURCE SELECT OUT
13 = TRIM OUTPUT
14 = FIELD REFERENCE
15 = FIELD FEEDBACK
16 = TEN RAMP OUTPUT
17 = POS RAMP OUTPUT
18 = OCL PARALLEL OUT
19 = OCL OUTPUT
20 = Power out
21 =
NETW IN REG 1
22 =
NETW IN REG 2
23 =
NETW IN REG 3
24 = Zero
25 = Full scale
26 =
DANCER LOADING
27 = TENSION DEMAND
28 = TAPER PERCENT
29 = DIAMETER ANALOG
30 = INERTIA COMPENSATION
Table 8.1 – File N10:x (Drive Read/Write Parameters) for WebPak 3000 Drives (Continued)
File
Address Parameter Name
Parameter
Number Type Scale