User guide

8-8 ControlNet Network Communication Option Board For Use With FlexPak 3000 and WebPak 3000 DC Drives
N10:194 FIELD CURRENT 1 P.522 Config 1 = 0.01 amp
N10:195
FIELD CURRENT 2 P.523 Config 1 = 0.01 amp
N10:196
FIELD CURRENT 3 P.524 Config 1 = 0.01 amp
N10:197
FIELD CURRENT 4 P.525 Config 1 = 0.01 amp
N10:198
FIELD CURRENT 5 P.526 Config 1 = 0.01 amp
N10:199
FIELD CURRENT 6 P.527 Config 1 = 0.01 amp
N10:200
FIELD CURRENT 7 P.528 Config 1 = 0.01 amp
N10:201
FIELD CURRENT 8 P.529 Config 1 = 0.01 amp
N10:202
FIELD INPUT 1 P.530 Config 1 = 1 RPM
N10:203 FIELD INPUT 2 P.531 Config 1 = 1 RPM
N10:204 FIELD INPUT 3 P.532 Config 1 = 1 RPM
N10:205 FIELD INPUT 4 P.533 Config 1 = 1 RPM
N10:206 FIELD INPUT 5 P.534 Config 1 = 1 RPM
N10:207 FIELD INPUT 6 P.535 Config 1 = 1 RPM
N10:208 FIELD INPUT 7 P.536 Config 1 = 1 RPM
N10:209 FIELD INPUT 8 P.537 Config 1 = 1 RPM
N10:210 FIELD SHAPING TYPE P.539 Config 0 = SPEED, 1 = DIAMETER
N10:211 CT TURNS RATIO P.010 Config
N10:212
JOG OFF DELAY TIME P.121 Config 1 = 1 s
N10:213
STOP DECEL SELECT P.122 Config 1 = 0.1 s
N10:214
NOMINAL AC LINE FREQ P.306 Config 1 = 1 Hz
N10:215
NOMINAL AC LINE VOLTS P.307 Config 1 = 1 VAC
N10:216 PHASE LOSS DETECT EN P.609 Config 0 = DISABLE, 1 = ENABLE
N10:217 DIG OUT 1 SELECT P.409 Config 0 = LEVEL DETECTOR OUT 1
1 =
LEVEL DETECTOR OUT 2
2 = At speed
3 = In current limit
4 = Drive ready
5 =
CURRENT MEM COMMAND
6 = UNDERWIND COMMAND
7 = TENSION COMMAND
8 = STALL TENSION COMMAND
9 = SLACK TAKE UP COMMAND
10 = DIAMETER RESET TP
11 = ARMATURE BRIDGE POL
12 = FIELD ECONOMY ACTIVE
13 = NETW COMM STATUS
14 = NETW IN REG 1
15 =
NETW IN REG 2
16 =
NETW IN REG 3
17 =
SPEED PROFILER ENABLE
18 = DIAMETER CALC ENABLE
Table 8.1 – File N10:x (Drive Read/Write Parameters) for WebPak 3000 Drives (Continued)
File
Address Parameter Name
Parameter
Number Type Scale