User guide

ManualsBrandsRockwell Automation ManualsEquipmentFlex/WebPak 3000 DC Drive ControlNet, Network Communication Board, 915FK2101

7-13

N11:20 ANALOG MANUAL

REFERENCE

P.192 Analog Manual mode reference value, after scaling

N11:21

SPD SOURCE SELECT OUT P.193 Selected speed source value

N11:22

ANALOG MAN TRIM REF P.194 Trim reference value when analog input used for trim

N11:23

DRAW PERCENTAGE OUT P.196 Product of selected trim reference and TRIM RANGE

(P.109)

N11:24

TRIM OUTPUT P.197 Present value added to SPD SOURCE SELECT OUT

(P.193)

N11:25

SPEED RAMP INPUT TP P.198 Speed reference value immediately before S-curve

ramp

N11:26

SPEED RAMP OUTPUT P.199 Speed reference value immediately after S-curve

ramp

N11:27

IR COMPENSATION TP P.290 Value subtracted from ARMATURE VOLTAGE (P.289)

N11:28

ANALOG TACH FEEDBACK P.291 Analog tachometer value, after scaling

N11:29

PULSE TACH FEEDBACK P.292 Pulse encoder value, after scaling

N11:30

CURRENT COMPOUND TP P.293 Value subtracted from SPEED RAMP OUTPUT (P.199)

N11:31

JOG RAMP OUTPUT P.294 Jog reference value immediately after jog ramp

N11:32

SPD LOOP ERROR P.297 Difference between SPD LOOP REFERENCE (P.295) and

SPD LOOP FEEDBACK (P.296)

N11:33

SPD LOOP LAG OUTPUT P.298 Value immediately after speed loop forward path lag

N11:34

AC LINE VOLTAGE P.392 Measured AC line voltage (RMS value)

N11:35

AC LINE PERIOD P.393 Measured AC line period (µsec)

N11:36

ARMATURE BRIDGE POL P.394 0 = OFF (forward bridge active)

1 =

ON (reverse bridge active)

N11:37

J18 ARM I FB RESISTOR P.395 1 = 15 ohm, 2 = 20 ohm, 3 = 30 ohm, 4 = 39 ohm

N11:38

CML REFERENCE P.396 Reference value to the CML after rate and amplitude

limiting

N11:39

CML FEEDBACK

(5 OR 10 MS UPDATE)

P.397 CML feedback value after conditioning and scaling

N11:40

CML ERROR P.398 Difference between CML REFERENCE (P.396) and

CML FEEDBACK (P.397)

N11:41

ARMATURE DELTA P.399 Present armature firing angle, in µsec

N11:42

DIG IN 0 P.490 Digital input 0 (terminal 12 on regulator board); Brush

Wear, Jog Speed Select, or OCL Enable

N11:43

FREQ IN P.491 Frequency input (terminals 39, 40, 41 on the

I/O Expansion board)

N11:44

ANLG IN 1 P.492 Analog input 1 (terminals 50, 51 on the I/O Expansion

board)

N11:45

ANLG IN 2 P.493 Analog input 2 (terminals 52, 53 on the I/O Expansion

board)

N11:46

DIG IN 1 P.495 Digital input 1 (terminal 59 on the I/O Expansion

board) Preset A

Table 7.2 – File N11:x (Drive Display Data (Read Only)) for FlexPak 3000 Drives (Continued)

File

Address Parameter Name

Parameter

Number Description