User guide

2-2
ControlNet Network Communication Option Board For Use With FlexPak 3000 and WebPak 3000 DC Drives
Step 4. Remove the screws that attach the carrier shield to the carrier. See
figure 2.2.
Step 5. Remove the connector that attaches the shield ground wire to the drive
power supply. Set the shield aside. See figure 2.3.
Step 6. Position the network option board over the standoffs. Refer to figure 2.4.
Step 7. Secure the network option board using three captive screws on the board.
Step 8. Plug the network option board ribbon cable into the network option board.
Figure 2.2 – Removing the Carrier Shield
Figure 2.3 – Removing the Shield Ground Wire
Carrier Shield
Ground Wire
Power Supply