Configuration Guide Owner's manual

Chapter 5 Configuring FactoryTalk Historian
76 Rockwell Automation Publication HSE-IN025A-EN-E–September 2013
documentation of your firewall configuration utility for more
information.
NOTE
You need administrator privileges to perform the steps described below.
To manually configure the firewall:
• Open TCP/IP ports in the firewall to accept incoming
connections:
See the table below to learn which ports need to be open for
individual FactoryTalk Historian suites.
For this FactoryTalk
Historian suite:
Open these ports: Of this type:
Historian to Historian
Interface
5450 TCP
Asset Framework 5457
5459
TCP
TCP
Historian Server 5450
5454
5455
5456
5458
TCP
TCP
TCP
TCP
TCP
Live Data Interface 6000 TCP
• Allow FactoryTalk Historian Live Data Interface to
communicate through the firewall:
See the table below to learn which settings you need to use
when configuring the firewall.
Item Description
The absolute path to
the Live Data
interface
<PIHOME_Value>Interfaces\LDInterface\FTLDInt.exe,
where <PIHOME_Value> is the path specified in the
following registry key:
Computer > HKEY_LOCAL_MACHINE > Software >
Wow6432Node > PISystem
The name (ID) of the
Live Data interface
PIUniint Interface to the PI System.