Configuration Guide Owner's manual

Upgrading FactoryTalk Historian SE Appendix E
Rockwell Automation Publication HSE-IN025A-EN-E–September 2013 173
NOTE
For more information on the migration process, refer to the KB
article 491889
(https://rockwellautomation.custhelp.com/app/answers/detail/
a_id/491889) on the Rockwell Automation Knowledgebase site.
• If you are using FactoryTalk Historian Live Data Interface
2.10 or 2.20, you need first to uninstall the interface, and then
install the new version.
• If you are using FactoryTalk Historian Live Data Interface 3.0
or 3.01, follow the steps below.
To upgrade your FactoryTalk Historian Live Data Interface to
the current version:
1. Stop PI services:
1. Go to Start > Run. The Run dialog box appears.
2. Type services.msc. The Services dialog box appears.
3. Find the following services:
• PIPC Log Server
• PI Network Manager
4. For each service, right-click it, and then select Stop.
NOTE
When you stop the PI Network Manager, the following
services are also stopped automatically:
• PI Message Subsystem
1. Wait until the service is stopped.
2. Install the FactoryTalk Historian Live Data Interface.
See "Install FactoryTalk Historian Live Data Interface (page
38)" for details.