Installation Guide 5.0 Owner manual

CONTENTS
iv
• • • • •
“Error executing ProCalV5 commands, check ProCalV5 installation” appears
when attempting to use Calibration Management features. . . . . . . . . . . . . . . . 80
“Error initializing FactoryTalk AssetCentre. Could not load file or assembly…
CalibrationPlugin.dll” appears when attempting to start the client . . . . . . . . . 80
Unable to run the ProCalV5 software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80
Unable to run the ProCalV5 Data Source Edit Wizard . . . . . . . . . . . . . . . . . . . . 81
A • Reference 82
Additional ports you may have to open . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 82
Index 86
FTAC-IN005A-EN-E.book Page iv Monday, March 4, 2013 4:03 PM