Installation Guide 5.0 Owner manual

1 • INTRODUCTION
10
• • • • •
About the installation process
Installing FactoryTalk AssetCentre software is a multiple-part process.
1. Install the prerequisite software for the FactoryTalk AssetCentre server.
2. If you have purchased the Calibration Management capability, install the ProCalV5
server.
3. Install the FactoryTalk AssetCentre server.
4. Install FactoryTalk AssetCentre clients.
5. If you have purchased the Calibration Management capability, install the ProCalV5
clients.
6. Install FactoryTalk AssetCentre agents.
7. Configure users and security.
8. If you have purchased the Process Device Configuration capability, install DTMs.
The following chapters guide you through these tasks.
To upgrade an RSMACC system to FactoryTalk AssetCentre, follow the instructions in Answer ID
454396 at http://rockwellautomation.custhelp.com/cgi-
bin/rockwellautomation.cfg/php/enduser/std_adp.php?p_faqid=454396
FTAC-IN005A-EN-E.book Page 10 Monday, March 4, 2013 4:03 PM