Installation Guide 5.0 Owner manual

1 • INTRODUCTION
7
• • • • •
To do a Rockwell Automation Compare, you must install the appropriate
programming software on the client computer.
 (optional) RSLinx Enterprise version 5.00 or later if your system includes PanelView
Plus operator interfaces
 (optional) FactoryTalk View ME Transfer Utility version 7.00 or later if your system
includes PanelView Plus operator interfaces
 (optional) DriveExecutive™ Lite version 5.01 or later if your system includes
Rockwell Automation drives
 (optional) Editing software for Siemens S5 or S7 processors, including SIMATIC
Manager (Step 7), Step 5, S5 for Windows, ACCON-PG, and PG-2000
Agent computer requirements
Computers running the FactoryTalk AssetCentre agents must meet the following
minimum requirements.
Hardware requirements:
 PC with 2 GHz or higher dual core processor recommended
 2 GB of RAM (or more, depending on application requirements)
 3 GB of free hard disk space (or more, depending on application requirements)
 Graphics adapter capable of a minimum resolution of 1024 x 768 pixels
 Keyboard and pointing device (mouse)
 Network adapter card
For this device... Install...
PLC-5 RSLogix 5
SLC 500, MicroLogix RSLogix 500
ControlLogix RSLogix 5000 Compare utility
Rockwell Automation drives DriveExecutive Lite
FTAC-IN005A-EN-E.book Page 7 Monday, March 4, 2013 4:03 PM