t Owner manual

276 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
Configure FactoryTalk View ME for the E3 Plus Module Faceplate
Follow these procedures to configure the faceplate.
Add E3 Plus Module Faceplate to ME Application
1. Launch FactoryTalk View Studio software and create or open an existing application file.
2. In the Graphics folder, right-click on Displays and choose ‘Add Component Into Application’.
3. Navigate to the ME E3 Plus Faceplate Files folder, select the E3Plus_Faceplate_Energy.gfx file, and click Open.
Add a Parameter File
1. Right-click on Parameters, and choose 'Add Component Into Application'.
2. Navigate to the ME E3PLUS Faceplate Files folder, select the E3Plus_Parameter.par file, and click Open.