t Owner manual

270 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
6. If Data Mapping is not set to Generic, click ‘Change’ under the Module Definition and set Data Mapping to
Generic.
7. Click OK to close the Module Properties window.
Import the E3 Plus Module Faceplate Routine
1. From the Controller Organizer, right-click on the program where you would like to add the E3 Plus module
faceplate routine, and choose Import Routine.
IMPORTANT
The E3 Plus faceplate AOI has been configured to work with the Generic data mapping. If you change the data mapping to a
specific type of E3 the AOI does not function properly.