t Owner manual

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014 269
FactoryTalk View ME Energy Faceplates Chapter 11
4. Expand the Communications folder and select the ‘193-DNENCAT’ (or 193-DNENCATR) module and click
OK.
5. Enter a distinct module name and the IP Address of your DNENCAT module.
(For example, we use ‘Motor_1’ for the module name throughout this document.)
The default setting for Data Mapping is Generic.
IMPORTANT
If this module is not available in the list, you can update the Add-on Profile for your device. Refer to Appendix E for more
information on updating the Add-on Profiles.