t Owner manual

250 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
5. Enter a distinct module name and the IP Address of your drive.
(For example, we use ‘Motor_1’ for the module name throughout this document.)
6. Click Change to launch the Module Definition window.
7. Select the firmware of the device you are using.
IMPORTANT
The IP address must match with that of your 20-COMM-E module. This step assumes you already assigned an IP address to your 20-
COMM-E module. Refer to the PowerFlex 20-COMM-E EtherNet/IP Adapter User Manual, publication 20COMM-UM010
, for
information on how to assign it an IP address.
IMPORTANT
If the firmware revision of your drive is not listed, refer to the lower left corner of the Module Definition window for instructions on
how to create a database.