t Owner manual

122 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 6 FactoryTalk EnergyMetrix Software Device Setup
Configure Communication Drivers
Before setting up devices, you need to configure the drivers required for communication. This example uses the RSLinx
Classic Ethernet driver for the PowerMonitor and ControlLogix devices, and the Kepware OPC driver for the Data Center
device.
Configure RSLinx Ethernet Driver
Follow these steps to configure the RSLinx Classic Ethernet driver.
1. Open RSLinx Classic by clicking its icon
in the W i nd ow s Sy ste m Tra y ( SysTr a y ) .
2. Choose Configure Drivers from the
Communications menu.
3. Choose Ethernet Devices from the
pull-down menu.
4. Click Add New.
5. Click OK to accept the default driver
AB_ETH-1.