Manual

DeviceNet Module Parameters B-3
Displays the DeviceNet data rate currently being used by the
module.
This parameter is a command. It will be reset to 0 = Ready after the
command has been performed.
5 DN Rate Act
Range: 0 = 125 kpbs
1 = 250 kbps
2 = 500 kbps
3 = Autobaud
Default: 0 = 125 kbps
Type: Read Only
Reset Required: N/A
6 Reset Module
Range: 0 = Ready (No action)
1 = Reset Module
2 = Set Defaults (Restores module to factory-default
settings)
Default: 0 = Read
Type: Read/Write
Reset Required: No
!
ATTENTION: If the module is transmitting I/O that
controls the drive, the drive may fault when you reset
the module. Determine how your drive will respond
before resetting a connected module. Failure to
observe this precaution could result in bodily injury
or damage to equipment.