User manual

Using Multi-Drive Mode 7-3
• Automatic Device Replacement (ADR) cannot be used with any of
the drives.
• The RSNetWorx Parameter editor cannot be used.
• Since the RS-485 ports are used for daisy-chaining the drives, there
is no connection for a peripheral device such as a HIM. The
AK-U0-RJ45-SC1 DSI Splitter cable cannot be used to add a second
connection for a peripheral device.
To daisy-chain the drives off the PowerFlex 40 with the 22-COMM-D
adapter (Drive 0), the AK-U0-RJ45-TB2P terminal block connector
(Figure 7.3
) can be used for easy installation.
Figure 7.3 AK-U0-RJ45-TB2P Terminal Block Connector
The wiring diagram for using AK-U0-RJ45-TB2P terminal block
connectors is shown in Figure 7.4.
Figure 7.4 AK-U0-RJ45-TB2P Connector Wiring Diagram
System Wiring
PowerFlex 40
with 22-COMM-D
Drive
#2
Drive
#3
Drive
#4
Drive
#5
120 Ω
¼ Watt
Resistor
120 Ω
¼ Watt
Resistor