User manual

1-8 Overview
• A PC that is:
– Running RSNetWorx for DeviceNet.
– Connected to and communicating with the DeviceNet
network using a 1784-PCD card or a 1770-KFD adapter.
– Running RS Linx.
– Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.
1336-GM6 Board
To install and configure a 1336-GM6 board, you need the following:
• Enhanced DeviceNet communications board (1336-GM6).
• A kit that includes one grounding wrist strap, four Phillips
mounting screws, four stand-off nylon headers, one 5-pin
connector and one snap-in comm housing with mounting
instructions (supplied with board).
• #1 Phillips screwdriver.
• Appropriate cable for the DeviceNet connection. Refer to the
Selecting Cables section in Chapter 2, Installation.
• A PC that is:
– Running RSNetWorx for DeviceNet.
– Connected to and communicating with the DeviceNet
network using a 1784-PCD card or a 1770-KFD adapter.
– Running RS Linx.
– Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.