230 VAC

DWELL TIME

The DWELL TIME trimpot setting determines the length

of time the motor stops before rotating in the opposite

direction. DWELL TIME only works when the drive is set

for Mode 2 and Mode 3 (see page 24 for limit switch

operating modes).

There are 10 DWELL TIME settings (0 thru 9). Set the

DWELL TIME to 0 (the factory setting) for 0.1 second

delay. Increasing the setting one increment higher adds 0.1

second to the dwell time. Set the DWELL TIME trimpot to

9 for approximately 1 second delay.

39Calibration

250-0285-rev1.qxd 4/26/00 9:36 AM Page 39