230 VAC

Calibration

ATTENTION: Dangerous voltages exist on the drive

when it is powered, and up to 30 seconds after power is

removed and the motor stops. When possible,

disconnect the voltage input from the drive before

adjusting the trimpots. If the trimpots must be adjusted

with power applied, use insulated tools and the

appropriate personal protection equipment. BE ALERT.

High voltages can cause serious or fatal injury.

ATTENTION: The control circuit is at line potential

when the drive is energized. Use a non-metallic

screwdriver when making adjustments to the circuit

board potentiometers. Exercise extreme caution as

hazardous voltage exists. Failure to observe these

precautions could result in severe bodily injury or loss

of life.



250-0285-rev1.qxd 4/26/00 9:36 AM Page 28