230 VAC User Manual

Installation

Figure 8. Enclosed Drive Connections

Connect the AC line power leads to terminals L1 and L2 as shown in Figure 8, or

to a double-pole, single-throw master power switch (recommended). Ensure that

earth ground is connected to the green screw inside the case.

ATTENTION: Installation of a master power switch in the input line is

required. This is the only way to disconnect power from the motor. The user is

responsible for assuring safe conditions for operating personnel by providing

suitable guards, audio or visual alarms, or other devices. Failure to observe

these precautions could result in bodily injury.

Power input

NOTE: TERMINAL 1 IS THE HOT

CONNECTION. TERMINALS 2 AND 3

ARE NEUTRAL CONNECTIONS.