Installation Owner's manual

Rockwell Automation Publication CHPS-UM001D-EN-P - July 2014 63
Chapter 10
Removing and Replacing Stage Components
Before You Begin
The following tools are required before you begin removal and replacement
procedures.
• To r q u e w r e n c h
• Phillips head screw driver
• 2.5 mm hex wrench
• 3 mm hex wrench
• 4 mm hex wrench
• Fine-point permanent marker
• Tin snips
• Loctite 222
Cable Carrier Module
Removal
Use this procedure to remove the cable carrier module assembly.
1. Remove the four (4) pan head screws from junction box side cover.
2. Remove the two (2) button head cap screws (BHCS) from the junction
box cover.
Topic Page
Before You Begin 63
Cable Carrier Module Removal 63
Cable Carrier Module Installation 64
Strip Seal Removal 65
Stage Cover Removal 65
Stage Side Cover Removal 65
Strip Seal Replacement 66
Stage Cover Installation 67
Side Cover Installation 67
TIP
Mark the location of the end bracket before removing the cable carrier, this
makes it easier to align the carrier when re-installing.