Installation Owner's manual

30 Rockwell Automation Publication CHPS-UM001D-EN-P - July 2014
Chapter 4 Mounting the Stage
Figure 6 - Through Bolt Mounting
An uncovered stage is a good candidate for through bolt mounting.
For covered stages, toe clamps are the easiest method for mounting. On sides of
the base secure a toe clamps every 120 mm (4.72 in) by using M6 SHCS as shown
in the Toe Clamps Mounting
diagram. Use slots formed into outside edge of the
stage base.
Figure 7 - Toe Clamps Mounting
IMPORTANT
Through bolt mounting is not available for the catalog number
CHPS-x6xxxx-xxxxx (150 mm) stages.
120 mm
(4.72 in.)