Instructions (DSI MDI) Owner's manual

Installation Instructions
RJ45 Splitter Cable (Catalog No. AK-UO-RJ45-SC1)
for use with DSI/ MDI Drive Products
Important: For connectivity guidelines relating to all configurations, see next page.
Connecting One Temporary Peripheral Connecting Two Permanent Peripherals
Connecting One Temporary Peripheral
and One Permanent Peripheral
Connecting an RS-485 Network
M
S
DSI / MDI Drive
Serial Converter
Parameter 1 [Adapter Cfg] set to "Auto"
(default) or "Master" and connected to
Master port (M) on RJ45 Splitter Cable
SelEsc
LANGDISP
EscEsc SelSel
8 9
ALT
7
4 5
6
Jog
1 2
3
.
0
+/-
DSI
REMOVE
DSI / MDI
Hand Held
or
Parameter 9 [Device Type] set to "Auto"
(default) or "Master" and connected to
Master port (M) on RJ45 Splitter Cable
M
S
NEMA 4
Panel Mount Unit
or
NEMA 1 Bezel
with DSI / MDI
Hand Held
DSI /MDI Drive
or
Parameter 9 [Device T
yp
e] set to
"M
as
t
e
r"
a
n
d
co
nn
ec
t
ed
t
o
M
as
t
e
r
p
ort (M) on RJ45 S
p
litter Cabl
e
SelEsc
Jo
g
|
D
SI
REM
O
V
E
Jo
g
|
D
S
I
REM
O
V
E
Parameter 9 [Device Type]
set to "Slave" and
connected to Slave port (S)
on RJ45 Splitter Cable
ALT
Jog
REMOVE
9
ALT
6
Jog
3
.
0
+
/
-
D
SI
REMOVE
M
DSI / MDI Drive
S
Serial Converter
NEMA 4
Panel Mount Unit
or
NEMA 1 Bezel
with DSI / MDI
Hand Held
Parameter 9 [Device Type]
set to "Master" and
connected to Master port
(M) on RJ45 Splitter Cable
Parameter 1 [Adapter Cfg]
set to "Auto" (default) or
"Slave" and connected to
Slave port (S) on
RJ45 Splitter Cable
Jo
g
|
D
SI
REM
O
VE
SelEsc
ALT
Jog
REMOVE
SelEsc
AK-U0-RJ45-TR1
Terminating Resistor
(end of network)
AK-U0-RJ45-TB2P
Two-position
Terminal Block
or
DSI / MDI Drives
or
Customer supplied RJ45 male-to-RJ45 male
cables with wires connected at pins 4 and 5 only.
Both the Master (M) and Slave (S) ports on the RJ45 Splitter
Cable operate as standard RS-485 ports in this configuration.
SelEsc