Manual

Publication DSSD3P-IN004A-EN-P

Gate Scaling Module (Part No. 97331001)

Installation Instructions

Follow these instructions to properly mount the Gate Scaling Module:

• Mount to a flat, grounded, metal panel.

• Mount in a suitable enclosure, in a clean, dry location. Contamination from

oils, corrosive vapors, and abrasive debris must be kept out of the enclosure.

• Mount in a horizontal position only, in order to provide proper cooling. The

lettering on the face of the unit should be in a readable position, as shown

below.

ATTENTION: Only qualified personnel familiar with DC drives

and associated machinery should plan or implement the installation,

start-up and subsequent maintenance of the system. Failure to

comply may result in personal injury and/or equipment damage.

ATTENTION: To avoid an electric shock hazard, ensure that all

power to the drive has been removed before performing the

following.

Engineered byEngineered by

GATE SCALING

MODULE

INPUT OUTPUT

Part No. 97331001

Notes:

Module Depth = 31.0 mm (1.22 in.)

Mounting Holes: 4.25 mm (0.17 in.)

124.0 mm

(4.88 in.)

138.0 mm

(5.43 in.)

60.5 mm

(2.38 in.)

37.25 mm

(1.47 in.)

(Center Diameter)

PAGE 1
Gate Scaling Module (Part No. 97331001) Installation Instructions ATTENTION: Only qualified personnel familiar with DC drives and associated machinery should plan or implement the installation, start-up and subsequent maintenance of the system. Failure to comply may result in personal injury and/or equipment damage. ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive has been removed before performing the following.
PAGE 2
www.rockwellautomation.com Power, Control and Information Solutions Americas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: (1) 414.382.2000, Fax: (1) 414.382.