Installation Instructions Manual

Technical Specifications
Default Settings
The following table provides an overview of the default settings. Information about
resetting the device to the default setting see Service.
Tip
If the device parameters have changed, enter these changes in the "Custom Value"
column. This provides an overview of your individual device settings.
Bul. 937C HART Loop Converter Installation Instructions
46
Menu Parameters Default setting Custom value
Unit
PV --- Type
auto
SV --- Type auto
TV --- Type auto
QV ---Type
auto
HARTcom Mode secondary
TimeOut 10 s
ComControl auto detect
ShortAddress 0
LocateMethod search
Output --- Iout1
Assignment disabled
Characteristic 4 - 20 NE43
Start value 0.000
End value 100.0
Fault current down
Output --- Iout2
Assignment disabled
Characteristic 4 - 20 NE43
Start value 0.000
End value 100.0
Fault current down