Installation Instructions Manual

Bul. 937C HART Loop Converter Installation Instructions
Calling up a Fault Message
1.
Use the 
or buttons to select the Fault message menu.
2. If the fault message menu i
s activated, press the OK button once.
The Restart inhibit submenu is disp
layed.
3. If the fault message menu i
s not activated, press the OK button twice.
The Restart inhibit submenu is displayed. The Fault
message menu is
activated and is marked as On.
The restart inhibit is used to prevent momentary trip value violations from not being
noticed by operating personnel.
1.
Use the 
or buttons to select On.
2. Conf
irm your selection with OK.
The relay status is retained after switching the relay.
3. If you would like to reset the relay status, press the ESC or
butt
on or restart the device.
The rela
y is reset. Exception: there is a fault message.
OK →
← ESC
On
OFF
▼
OK →
← ESC
Restart InhibitFault (On)
Fault Message
Activating the Restart Inhibit
40