Installation Instructions Manual

Bul. 937C HART Loop Converter Installation Instructions
Editing device data: Input
Sele
cting an Assignment
The values of th
e selected HART variable (PV, SV, TV, QV) are shown on the current
output. The number of available variables depends on the HART field device. When
selecting disabled, the downscale fault current of 0 mA or 2 mA is constantly present at
the current output, depending on the characteristic.
1.
Select the desired HART variable using t
he  or  buttons.
2. Conf
irm your selection with OK.
▼
Iout2
OK →
← ESC
▼
Iout3
▼
Rel1
Rel2
OK →
← ESC
down
up
▼
hold
▼
OK →
← ESC
▲▼
OK →
← ESC
End Value see section
Fault Current
same as Iout1
same as Iout1
30