USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
21–18
Receiving a Program — HHT to APS
You can transfer a user program from the HHT to the APS terminal using the
receive program function. In the following example, node 0 is the receiving APS
terminal, node 4 is the sending terminal.
1. Begin at the main menu on node 0, the receiving APS terminal. Press
CONFIG
OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2.
Press
CONFIG
OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
3. The default emulation is for an SLC 5/01 processor. If the program in the HHT
is for an SLC 5/02 processor, the APS terminal must be configured for an SLC
5/02 processor
. Press
CONFIG
OFFLINE
CONFIG
EMULATE
5/02
F7
.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0 Emulation: SLC 5/01
WHO LISTEN - Active Node Table
0 * 12 24
1 * 13 25
2 * 14 26
315 27
4 * 16 28
517 29
618 30
719 31
820
921
10 22
11 23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04