USER MANUAL APS 6.0

T ransferring Program Files
21–13
Sending a Program — APS to HHT
You can transfer a user program from the hard disk of the sending APS terminal to
the Hand-Held Terminal using the send program function.
In the following example, node 0 is the sending APS terminal, node 4 is the
receiving terminal.
1. Begin at the main menu on node 0, the sending APS terminal. Press
CONFIG
OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2.
Press
CONFIG
OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0 Emulation: SLC 5/01
WHO LISTEN - Active Node Table
0 * 12 24
1 * 13 25
2 * 14 26
315 27
4 * 16 28
517 29
618 30
719 31
820
921
10 22
11 23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04