USER MANUAL APS 6.0

T ransferring Program Files
21–3
Transferring Programs Between Programming Terminals
Sending a Program — APS to APS
You can transfer a user program from the hard disk of the sending APS terminal to
the workspace of the receiving APS terminal using the send program function.
In the following example, node 0 is the sending APS terminal and node 3 is the
receiving APS terminal.
1. Begin at the main menu on node 0, the sending APS terminal. Press
CONFIG
OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2.
Press
CONFIG
OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
At this point, node 0, your sending APS terminal is not active on the network.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0 Emulation: SLC 5/01
WHO LISTEN - Active Node Table
012 24
1 * 13 25
2 * 14 26
3 * 15 27
4 * 16 28
517 29
618 30
719 31
820
921
10 22
11 23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04