USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
13–18
DH+ Channel 1 Configuration (SLC 5/04 processors only)
When
the system mode driver is DH + for channel 1 pressing [F7] CH1 System
Configuration displays the following:
Communication Driver: DH+
Diagnostic File: Reserved
Baud Rate: 57600
Node Address: 1 (octal)
Global Status Word Transmit Enable 0
Global Status Word Receive Enable 0
Global Status Transmit Word S:99
Global Status Receive File S:100–S:163
F2
UNDO
EDITS
Press a key for desired function
REM PROG no forces EDITS: NONE PROC Addr 1
Channel 1 System Mode Configuration
F1
ACCEPT
EDITS
F9
CHAN
STATUS
F10
SELECT
OPTION
Global Status Word
parameters are available
only for SLC 5/04 OS401
processors.
Parameter
Description
Baud Rate
Toggles between the communication rate of 57.6K,
115.2K, and 230.4K. The default is 57.6K. A
programming terminal only can communicate on a DH+
link configured for 57.6 Kbaud. Make sure all devices
on your DH+ link are configured for the same
communication rate.
Node Address Valid range is 0-77 octal. The default is 1.
Global Status Word Transmit Enable
➀
Toggles between 0 and 1. The default is 0.
Global Status Word Receive Enable
➀
Toggles between 0 and 1. The default is 0.
➀
This parameter is only available for SLC 5/04 OS401 processors.