USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
13–16
Generic ASCII Channel 0 Configuration
When the user mode driver is Generic ASCII for channel 0 the following screen is
displayed:
Communication Driver: GENERIC ASCII
Diagnostic File: Reserved
Baud Rate: 1200 Parity: NONE
Stop Bits: 1 Data Bits: 7
Delete mode: IGNORE RTS off delay [20 ms]: 0
Echo: DISABLED RTS send delay [20 ms]: 0
Control Line: NO HANDSHAKING XON/XOFF DISABLED
Termination 1: \d Append 1: \d
Termination 2: \ff Append 2: \a
F2
UNDO
EDITS
Press a key for desired function
REM PROG no forces EDITS: NONE PROC Addr 1
Channel 0 User Mode Configuration
F1
ACCEPT
EDITS
F9
CHAN
STATUS
F10
SELECT
OPTION
Parameter Description
Diagnostic File Reserved for future use.
Baud Rate
Toggles between the communication rate of 110, 300, 600, 1200, 2400,
4800, 9600, and 19200. The default is 1200.
Parity Toggles between None, Odd, and Even. The default is None.
Stop Bits Toggles between 1, 1.5, and 2. The default is 1.
Data Bits Toggles between 7 and 8. The default is 8.
Delete Mode
Toggles between Ignore, CRT, and printer. The default is Ignore. This
parameter is dependent on the Echo parameter being Enabled.
Echo Toggles between Disabled and Enabled. The default is Disabled.
RTS Off Delay
Allows you to select the RTS off delay value in increments of 20 ms. Valid
range is 0-65535 (in 20 ms increment). The default is 0.
RTS Send Delay
Allows you to select the RTS send delay value in increments of 20 ms.
Valid range is 0-65535 (in 20 ms increment). The default is 0.
Control Line
Toggles between No Handshaking, HalfDuplex With Continuous Carrier,
HalfDuplex Without Continuous Carrier, and FullDuplex Modem. The
default is No Handshaking.
XON/XOFF Toggles between Disabled and Enabled. The default is Disabled.
Termination 1
Termination 2
Specify FF for no termination character.
Append 1
Append 2
Specify FF for no append character.