USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
12–8
2. Cursor to node 5 and press
CONFIG
OFFLINE
CONFIG
SET
OWNER
F3
. The display changes to the following:
0 TERM (31) 12 24
1 APS (31) 13 25
2 500-20 (31) 14 26
3 500-20 (31) 15 27
4 500-40 (31/0) 16 28
5 5/02 (5/0) 17 29
61830
71931
820
921
10 22
11 23
F2
STATION
DIAGS
Press a key for desired network function
WHO ACTIVE - Active Station Identification
ESC exits
F1
ONLINE
F3
SET
OWNER
F4
CLEAR
OWNER
F7
MAX
ADDRESS
F8
NODE
ADDRESS
F9
NODE
BAUD
If you have chosen the 1784-KT or 1784-KL as your communication device,
the set/clear owner function applies to the 1785-KA5 gateway only. If you set
owner, and then exit APS, no other DH-485 device is able to gain access until
either:
• the 1785-KA5 gateway power cycles, or
• another node on DH+ clears owner .
This is because the 1785-KA5 is the owner of the processor, not your terminal.
To indicate ownership by a programmer
, the node address of the owner is
included in the parentheses with the maximum node address. In this case, to
indicate ownership by terminal 0, “(31)” has changed to “(31/0)” for node 4 and
node 5 has changed to (5/0).
As long as terminal 0 is running APS, the APS terminal at node 1 can not
monitor the processor file or access the processor functions at nodes 4 and 5.
The message PROGRAM OWNER ACTIVE tells the user why he is denied
access.