USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
12–6
1. Begin at the main menu and press
CONFIG
OFFLINE
CONFIG
WHO
F5
, then
CONFIG
OFFLINE
CONFIG
WHO
ACTIVE
F5
. The following
display appears:
0 TERM (31) 12 24
1 500-20 (31) 13 25
2 500-30 (31) 14 26
3 500-40 (31) 15 27
41628
51729
61830
71931
820
921
10 22
11 23
F2
STATION
DIAGS
Press a key for desired network function
WHO ACTIVE - Active Station Identification
ESC exits
F1
ONLINE
F3
SET
OWNER
F4
CLEAR
OWNER
F7
MAX
ADDRESS
F8
NODE
ADDRESS
F9
NODE
BAUD
2. Cursor to the highest numbered node.
3.
Press
CONFIG
OFFLINE
CONFIG
MAX
ADDRESS
F7
and enter the number of the node you are on.
4.
Press [ENTER] . If the message: MAXIMUM NODE ADDRESS VIOLATION
DETECTED
appears, this informs you that APS has detected an active node on
the network with a node address higher than the APS maximum node address.
Note When
you cycle power to an SLC 5/01 Series A pr ocessor, the maximum node
addr
ess r eturns to the default selection of 31.
Y ou cannot change the maximum node addr ess of the terminal at this display . If you
attempt to change the addr ess, the message CURRENT DEVICE IS NOT A
PROCESSOR
appears.