USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
1–16
Running APS
You can run APS either from a DOS or a Windows environment.
Running APS in a DOS Environment
1. If necessary , change the drive specifier to the drive where the software is
installed (typically C). To do this, type:
C:
and press [ENTER].
2. If you are using the default directory, at the DOS prompt, type:
CD \IPDS\ATTACH\SLC500
and press [ENTER].
If you specified a different directory path, change to that directory and press
[ENTER].
3.
Use the table that follows to choose your next step:
To run APS: First: Then:
with
INTERCHANGE and
DH+ WHO
Type APS and
press [ENTER].
The APS main
menu appears.
with only DH+ WHO
Make certain the Windows drivers are stopped.
• If your AUTOEXEC.BAT contains this
command: \ABIC\BIN\ABICRUN,
type: \ABI \BIN\ABI STOP
Type IT and
press [ENTER].
The APS main
menu appears.
alone (without
INTERCHANGE and
DH+ WHO)
t
ype: \ABIC\BIN\ABICSTOP.
• If your AUTOEXEC.BAT contains this
command: \RSI\IC\BIN\ABICRUN,
type: \RSI\IC\BIN\ABICSTOP.
Type AP and
press [ENTER].
The APS main
menu appears.
Exiting the System: You can exit APS software and return to DOS by
accessing the APS main menu and pressing
CONFIG
OFFLINE
CONFIG
EXIT
SYSTEM
F10
.