USER MANUAL APS 6.0

Preface
Advanced Programming Software User Manual
11–30
Function Key Description
[F8] Board Address
1784KT
Allows you to enter the 1784KTs board dip switch setting in a binary
format. Valid range is 000000–111111. The default is 000011.
1784KT2
Allows you to select the four digit hexadecimal number that represents
the board segment address. Valid values are C000, C400, C800, CC00,
D000, D400, D800, and DC00. The default is C800.
[F9] Save to File Saves the selected parameters to the user file.
Interchange DH+ Direct
The Interchange DH+ configuration is only available when using an SLC 5/04
processor with an interface card. The Current Device field displays the interface
card installed in your personal computer.
The following interface cards are available for configuration via the initialization
file (cfg_kt.ini):
• 1784-KT
• 1784-KL
• 1784-KT2
• 1784-KTX
• 1784-PCMK with a 1785-PCM4 cable
Note You must edit the initialization file (cfg_kt.ini) found in the INTERCHANGE
dir
ectory in or der to use the Inter change DH + option. T o do this, use the
INTERCHANGE Device Configuration utility that was loaded during the APS
installation pr ocedur e. Refer to chapter 1 in this manual for configuration
information.
If the INTERCHANGE driver is not loaded or the INTERCHANGE port selected is
not configur ed for use, all entries in the online configuration scr een will display
asterisks (*), except SLC node addr esses and the curr ent INTERCHANGE port.
Refer to the
Instruction Set Refer ence Manual for more information on the Data
Highway Plus communication protocol.